Skip to content

Power and Energy

Power and Energy is a tab for setting the power and energy monitored by energy meters with pulse output or measuring current and voltage from sensors connected to the analog inputs INPA1 - INPA6.

Power and energy

Elements of page

  1. Name setting fields, power and energy measurements, and visibility check boxes for individual items on the Status page. In the upper right corner there is Check all checkbox to toggle visibility of all elements on Status page.

    In version HW 3.5+ it is possible to change unit of measurement by clicking on the field with unit of power. There are 4 options:

    • kW (energy expressed in kWh)
    • W (energy expressed in kWh)
    • l/min (energy expressed in m3)
    • m3/min (energy expressed in m3)
  2. Measurement configuration.

    Includes:

    • selection of measuring inputs
    • impulse conversion rate per kWh
    • field for entering a new state of energy measurement
    • function of storing readings (after selection LK remembers energy measurements after reboot)

Measurement with counter with pulse output

To the logic input INP1D - INP4D connect + (plus) the pulse output of the meter, to GND - (minus) from the counter. Then in the drop-down menu select the input INP1D - INP4D to which the counter is connected, and in the field below enter the number of pulses for 1kWh.

Measurement with analogue current and voltage sensors

From the left menu, select the INPA input to which the current sensor is connected, and in the right menu select the voltage input (sensor). In the case of measuring AC current with the SCT transconductors can be used to select the approximate voltage value in the electrical network.


Last update: 2020-10-29
Back to top